Control Rack Croppped

Neutron and Gamma Monitoring

Our BNCT control system enables direct measurement of Neutron and Gamma flux generated by the source. Very tightly integrated software and hardware forms the backbone of the safety and dosimetry system.

  • Counts Neutrons and Gammas and converts to delivered dose.
  • High speed - up to 200 million counts per second.
  • Built-in high voltage output and monitoring up to +/-2kV.
  • Support for up to 8 separate detectors all with simultaneous monitoring.
  • Customizable pre-amplifier for pulse shaping and baseline restoration.

Proton Flux Monitoring

In addition to Neutron monitoring, our BNCT systems can also monitor Proton flux and use real-time interlocks to check against expected and observed Neutron yields to catch a wide variety of potentially dangerous situations before they happen.

  • Real-time Proton beam current and position monitoring.
  • Fast response - from 10Hz to 100kHz data rate.
  • Supports single or quadrant detectors with positional information.
  • Sync with Neutron detection system to map Neutron/Proton yield accurately.
  • Integrated high voltage for electron suppression rings.

Control Room UX

The CM100 is a convenient tertiary counting dosimeter with an integrated control panel. The CM100 paved the way for other high-end control consoles and continues to excel with each iteration.

  • Touch screen and physical buttons
  • Key switch for hard authentication plus software verification
  • Audible and configurable dose indicator
  • Emergency stop with configurable relays for flexible workflows
  • Battery backup with up to 1 hour of run time